CFD Online Discussion Forums

CFD Online Discussion Forums (
-   Main CFD Forum (
-   -   running analysis in STAR-CD 4.16 (why an old file is being run?) (

huilian08 September 2, 2011 18:51

running analysis in STAR-CD 4.16 (why an old file is being run?)

We recently updated our STAR-CD to version 4.16, and since then I run into a bunch of problems, mainly because I do not use STAR-CD very often in the first place.

When I tried to run an analysis actively (it calles the subroutine posdat.f), but I found out it was running on an old file, not the one I just read and up-loaded in prostar. Why is this happening? I also did not see the files .prob, not sure if it is related to this issue or not.

Can anyone here provide any advice on this?


huilian08 September 2, 2011 19:04

here are the command I used to up_load the mesh file from Star-ccm+ to pro-star:


I can output fluid velocity data from all mesh cells fine, but somehow even after I save this into star.mdl, but the pro-star does not run the casename star? Instead, it ran a totally different old file.

Just more comments on the previous post to clarify the problem.


All times are GMT -4. The time now is 06:56.