 |
 |
 |
|
|
|
[Sponsors] | ||||
June 2, 2005, 02:07
|
Re: Mass Source ERROR
|
#1 |
|
Guest
Posts: n/a
|
hi,
I too experienced the same in Fluent.I am injecting helium in closed domain.After few time steps I checked the mass of helium inside the domain.I found that this mass is more than actual mass.I have seen even after i reduced the convergence criteria to 1e-11. Thanks |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Building OpenFOAM1.7.0 from source | ata | OpenFOAM Installation | 46 | March 6, 2022 14:21 |
| Compile calcMassFlowC | aurore | OpenFOAM Programming & Development | 13 | March 23, 2018 08:43 |
| [swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 19:00 |
| Installation OF1.5-dev | ttdtud | OpenFOAM Installation | 46 | May 5, 2009 03:32 |
| Compiling problems with hello worldC | fw407 | OpenFOAM Installation | 21 | January 6, 2008 18:38 |
Linear Mode
