|
[Sponsors] |
June 2, 2005, 01:07 |
Re: Mass Source ERROR
|
#1 |
Guest
Posts: n/a
|
hi,
I too experienced the same in Fluent.I am injecting helium in closed domain.After few time steps I checked the mass of helium inside the domain.I found that this mass is more than actual mass.I have seen even after i reduced the convergence criteria to 1e-11. Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Building OpenFOAM1.7.0 from source | ata | OpenFOAM Installation | 46 | March 6, 2022 13:21 |
Compile calcMassFlowC | aurore | OpenFOAM Programming & Development | 13 | March 23, 2018 07:43 |
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
Installation OF1.5-dev | ttdtud | OpenFOAM Installation | 46 | May 5, 2009 02:32 |
Compiling problems with hello worldC | fw407 | OpenFOAM Installation | 21 | January 6, 2008 17:38 |