Home > Forums > General Forums > Main CFD Forum

k-e Model-BC for Mass transfer from wet duct wall

Mark Forums Read

Reply

Search this Thread

June 24, 1999, 17:02	k-e Model-BC for Mass transfer from wet duct wall	#1
R.Sureshkumar Guest Posts: n/a	Hello I am looking for usefull articles, suggestion for the way BC to be handled for mass transfer from wet wall. I am using k-e model to simulate the air flow inside a square duct. Thanx in advance

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Commercial meshers] Fluent3DMeshToFoam	simvun	OpenFOAM Meshing & Mesh Conversion	50	January 19, 2020 16:33
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug	unoder	OpenFOAM Installation	11	January 30, 2008 21:30
Standard wall function vs Two layer model	C. ORTEGA	FLUENT	0	July 7, 2003 09:35
BC-For Mass Transfer From Wet Duct Wall	R.Sureshkumar	Main CFD Forum	0	June 22, 1999 09:27
Wall functions	Abhijit Tilak	Main CFD Forum	6	February 5, 1999 02:16

All times are GMT -4. The time now is 01:52.