 |
 |
 |
|
|
|
[Sponsors] | ||||
How to generate the geometry of Hydrofoil impeller with Ansys designmodeler |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 15, 2011, 09:43
|
How to generate the geometry of Hydrofoil impeller with Ansys designmodeler
|
#1 |
|
New Member
Li Liu
Join Date: Nov 2009
Posts: 16
Rep Power: 0  |
Dear all,
I am trying to use the Ansys designmodeler to generate the geometry of a Hydrofoil impeller which you can see in the picture attached here, but because the blades are not flat, I found it is hard to use the Ansys designmodeler to do this. Has anyone done this before or have any idea? I really appreciate your kind help. Best Wishes,Lily |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Physical size of geometry in DesignModeler | Michael Rasmussen | CFX | 9 | June 16, 2017 04:27 |
| Importing Ansys .cdb mesh and geometry into CFX 11 | Tom | CFX | 1 | February 18, 2008 12:08 |
| Problem importing GAMBIT mesh to Ansys geometry | David G. | CFX | 0 | June 19, 2005 07:01 |
| Stirred Tank Geometry in Ansys | gopalkasat | CFX | 6 | December 22, 2004 14:32 |
| Virtual/Real geometry. | Jack Keays | FLUENT | 9 | June 16, 2000 00:39 |
Linear Mode
