 |
 |
 |
|
|
|
[Sponsors] | ||||
Comparing pressure measurements windtunnel <> simulation |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 7, 2012, 11:03
|
Comparing pressure measurements windtunnel <> simulation
|
#1 |
|
New Member
Merend
Join Date: Jan 2011
Posts: 12
Rep Power: 15  |
Hello,
please advise on the following problems, thanks a lot (1) when i compare pressure measurements in atomospheric boundary law[Pa] from a wind tunnel to a simulation (scaled geometry). Do I need to convert them to the pressure coefficient for that first? If yes - how to? I have the pressure difference to the ambient pressure, the same velocity and density in both cases - so no use of a dimensionless number - correct? Thanks a lot! |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Discrepancy between the measurements (pressure drop; VOF) | blackemperor | FLUENT | 2 | March 6, 2016 03:40 |
| How to monitor pressure in trasient simulation of a rotating blade? | ripperjack | CFX | 4 | December 16, 2011 01:30 |
| Fluent natural ventilation pressure boundary condition | pierresandre | FLUENT | 24 | November 8, 2011 14:32 |
| stagnation pressure in transient flow simulation | K.S.Ravichandran | Main CFD Forum | 2 | September 5, 2000 00:34 |
| Hydrostatic pressure in 2-phase flow modeling (long) | DS & HB | Main CFD Forum | 0 | January 8, 2000 15:00 |
Linear Mode
