 |
 |
 |
|
|
|
[Sponsors] | ||||
How to put boundary condition on a 3D cylinder in Gambit? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 30, 2012, 00:12
|
How to put boundary condition on a 3D cylinder in Gambit?
|
#1 |
|
Member
Behrang Asgharian
Join Date: Oct 2009
Posts: 38
Rep Power: 16  |
Hi
I am new to 3D modeling and I have been doing only 2D modelings. I made a a cylinder in Gambit but when I want to specify one end as velocity inlet it chooses the whole cylinder. What should I do? It is different from 2D modeling. Thanks Behrang |
|
|
|
|
|
March 30, 2012, 09:21
|
|
#2 |
|
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
if it chooses the whole cylinder, then you only have one surface.
But if you create a basic cylinder in gambit, you should have 3 surfaces: top, bottom and the generated surface. And pick surface for BC, not volume
__________________
In memory of my friend Hervé: CFD engineer & freerider  |
|
|
|
|
|
|
March 30, 2012, 12:19
|
|
#3 |
|
Member
Behrang Asgharian
Join Date: Oct 2009
Posts: 38
Rep Power: 16 |
Thank you
I figured it out. |
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| inlet velocity boundary condition | murali | CFX | 5 | August 3, 2012 08:56 |
| asking for Boundary condition in FLUENT | Destry | FLUENT | 0 | July 27, 2010 00:55 |
| Boundary Condition in Gambit & Fluent | Raed141 | ANSYS Meshing & Geometry | 0 | January 12, 2010 03:47 |
| Boundary Condition in Gambit | Kirit | FLUENT | 3 | December 18, 2008 20:41 |
| CFX Solver : Sudden crash | Hervé | CFX | 2 | June 16, 2008 06:40 |
Linear Mode
