[jstaylor89]

I have a CFX simulation that is basically a pipe with inlet and outlet orifice's. the simulation runs over 4.5ms, with a time step of 0.1ms. I now need to run the same simulation but with inlet events before this to try and replicate initial conditions. This brings the whole simulation to 1050ms (1.05s), but I only need the results from the last 4.5ms as before.

I have it all set up but running it now would give me 10500 time steps and take 600+ hours and 240GB results.

The accuracy of the first 700ms is not so important so ideally I want a time-step of 10ms for the first 700ms, then change to a 0.1ms time-step after this. Is this possible and if so, how?

I would also like to only record the results near the end. I have tried setting trn results to, Time Interval: t>0.99[s], but this gives me a resolves to dimensionless error. Any ideas on this?

Cheers