|May 29, 2013, 05:46||
Salome 3D Mesh generation
Join Date: May 2013
Posts: 3Rep Power: 5
Hi, I'm working on a complex shape and i need to generate a 3D Mesh of this element, that is a cylinder with some cuts inside. I used the software Salome to create this geometry, but when I try to generate the 3D Mesh of this element I only can generate it with a too high dimention of cells. The algorithm I used are:
3D: Tetrahedron (Netgen) --> Hypothesis:Max element volume 8
2D: Triangle (Mefisto) --> Hypothesis:Max element area 8
1D: Wire discretisation --> Hypothesis:Local length 3
But these dimentions are still too big for my mesh. When i try to set smaller values Salome gives an error and generates the Mesh only on the surfaces.
The error is:
Exception in netgen::OCCGenerateMesh() at Volume meshing
I would need to set local length = 2 or =1
Can anybody help me with this? I attached the file with my geometry here!
Thank you so much in advance!
|Thread||Thread Starter||Forum||Replies||Last Post|
|Add Mesh Layers doesnt work on the whole surface||Kryo||OpenFOAM Native Meshers: snappyHexMesh and Others||8||September 13, 2012 09:28|
|[ICEM] Need urgent help for hybrid mesh generation||Pursuor||ANSYS Meshing & Geometry||1||August 29, 2012 16:04|
|[ICEM] Mesh generation||bobinson||ANSYS Meshing & Geometry||2||August 17, 2012 13:23|
|checkMesh and decomposePar crashes with salome IDEAS mesh||pajofego||OpenFOAM||0||June 23, 2011 08:43|
|General questions on grid-based computing||Adrin Gharakhani||Main CFD Forum||21||June 5, 2000 13:47|