 |
 |
 |
|
|
|
[Sponsors] | ||||
November 3, 2014, 16:36
|
Geometry cleaning
|
#1 |
|
New Member
A.Nonymous
Join Date: Oct 2014
Posts: 2
Rep Power: 0  |
Hi all,
I am facing a simple problem that some of you may have encountered already. I am cleaning some geometry before cleaning it and I end up with some some coincident faces (see attached pic). How would you remove that using free software (i.e. gmsh, netgen, freecad, etc...) ? If you have any process for this kind of problem or know a good thread on that, that would be very helpful! Thanks for reading this. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Running CFD parallel. There is no geometry file! | CrashLaker | SU2 | 6 | April 10, 2014 03:08 |
| [CAD formats] translating geometry from Abaqus to OpenFOAM | skuznet | OpenFOAM Meshing & Mesh Conversion | 3 | January 10, 2014 13:49 |
| Geometry for Confined Circular Jet | Greatness | FLUENT | 0 | October 1, 2013 05:04 |
| Problem Importing Geometry ProE to CFX | fatb0y | CFX | 3 | January 14, 2012 19:42 |
| 2D geometry to 3D geometry | Sgonzalezg | ANSYS Meshing & Geometry | 11 | April 8, 2011 11:02 |
Linear Mode
