NREL Phase VI Geometry

Eslam Hashem · September 14, 2014, 08:51

I'm asking for a Geometry for NREL Phase VI wind turbine to do my case validation. I tried to sketch it but unfortunately i found that it contains some defects. Please if anyone have this geometry, i will be grateful if he send it.

one of the issues that made sense of conflict that the blade tip angle is set to 3 degree towards the feather (towards wind direction)
from the rotor plane. while in the table describing the Blade chord and twist distributions shows that a negative twist angle starting from 3.781 til the tip. I made my model like this table but i don't know how to pitch the blade tip by 3 degree in the same time.

Eslam

kcengiz · April 10, 2015, 08:19

i have been desperately look for UAE Phase VI blade geometry on the web. Unfortunately, everybody has it, no one gives it..
I think i have to create the cad geometry myself, though i am not very competent at cad software.

April 10, 2015, 08:19	so do i	#2
kcengiz New Member kenan Join Date: Sep 2012 Posts: 9 Rep Power: 14	i have been desperately look for UAE Phase VI blade geometry on the web. Unfortunately, everybody has it, no one gives it.. I think i have to create the cad geometry myself, though i am not very competent at cad software.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Modeling a two phase flow in a concentric cylindrical geometry	rshbhb	FLUENT	4	June 30, 2021 16:42
Simulation of NREL UAE Phase VI turbine	aqstax	FLUENT	63	June 25, 2014 10:28
Request for NREL Phase VI data for method validation	mohammad	FLUENT	0	March 24, 2013 08:59
Problem Importing Geometry ProE to CFX	fatb0y	CFX	3	January 14, 2012 19:42
Geometry setup for phase change problem	Fred G. Kang	Main CFD Forum	1	October 14, 1998 11:41