Home > Forums > Special Topics > Mesh Generation & Pre-Processing

[GMSH] Extrude surface using scale factor

Mark Forums Read

Reply

Search this Thread

July 20, 2015, 22:07	[GMSH] Extrude surface using scale factor	#1
nthiers New Member Nicolas Thiers Join Date: Mar 2015 Posts: 17 Rep Power: 10	Hello everyone, am trying to create a structured mesh inside a truncated cone, using the "extrude" function i get a structured cilinder, it is posible to use a scale factor in the extrude function to get a structured truncated cone? if anyone could help me i'll really appreciate Nicolas

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible	velan	OpenFOAM Meshing & Mesh Conversion	3	October 22, 2015 11:05
[snappyHexMesh] Problem with Sanpper, surface still Rough	Zephiro88	OpenFOAM Meshing & Mesh Conversion	7	November 5, 2014 12:05
[Gmsh] Cannot get the right mesh from gmsh	JinBiao	OpenFOAM Meshing & Mesh Conversion	2	August 31, 2010 04:51
[Gmsh] boundaries with gmshToFoam‏	ouafa	OpenFOAM Meshing & Mesh Conversion	7	May 21, 2010 12:43
Cross section and surface area factor	Fabiana	CFX	0	January 9, 2006 23:51

All times are GMT -4. The time now is 10:34.