Home > Forums > Special Topics > Mesh Generation & Pre-Processing

Unwanted internal Mesh in OpenFOAM, using blockMesh

Mark Forums Read

Reply

Search this Thread

October 29, 2015, 08:10	Unwanted internal Mesh in OpenFOAM, using blockMesh	#1
nitishanand1989 New Member Nitish Join Date: Oct 2015 Location: Delft, Netherlands Posts: 5 Rep Power: 12	Dear Foamers, I am relatively new to OpenFoam. I have been trying to create a wedge type mesh for a sphere using blockMesh. However, by using blockMesh I am generating a set of unwanted internalMesh, which creates voids in my geometry. I have also attached screen-shots of the meshes generated. without_internalMesh.jpg Volume.jpg With_internalMesh.jpg I want to fix this problem. Please give me your suggestions.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
snappyhexmesh remove blockmesh geometry	philipp1	OpenFOAM Running, Solving & CFD	2	December 12, 2014 11:58
[snappyHexMesh] Unwanted mesh created by snappyHexMesh--baffle	bieshuxuhe	OpenFOAM Meshing & Mesh Conversion	2	April 23, 2014 02:59
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 22:11
[Commercial meshers] Fluent Mesh to OpenFoam: Internal Surface has to be a wall	sebastian	OpenFOAM Meshing & Mesh Conversion	6	October 21, 2010 05:36
Icemcfd 11: Loss of mesh from surface mesh option?	Joe	CFX	2	March 26, 2007 19:10

All times are GMT -4. The time now is 16:13.