|
[Sponsors] |
September 27, 2016, 13:03 |
icem problem
|
#1 |
Member
Join Date: Jan 2012
Posts: 30
Rep Power: 14 |
hi all,
can anybody know the problem shown in the pictures? the mesh is not tightly attached the curve. I have tried to with small size of mesh, however, this problem cannot be fixed. thanks in advance shuai |
|
June 26, 2017, 01:27 |
ICEM Expert
|
#2 |
Member
sila
Join Date: Jul 2013
Posts: 32
Rep Power: 12 |
Hi,
You can follow the below steps. 1. Change the triangulation tolerance Or 2. delete and create particular surface and curves in icem or let me know if you cant do it.. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] Problem with cyclic boundaries in Openfoam 2.3, mesh import from ICEM | Scabbard | OpenFOAM Meshing & Mesh Conversion | 29 | October 6, 2020 21:14 |
[ICEM] ICEM CFD Problem with the boundary conditions while importing the mesh to fluent | sonic109 | ANSYS Meshing & Geometry | 2 | September 3, 2014 00:56 |
Problem with usnstruct mesh Icem Tribometer | obliz | ANSYS | 0 | July 10, 2014 03:09 |
[ICEM] ICEM problem when doing not so fine mesh | DudaAPD | ANSYS Meshing & Geometry | 0 | April 30, 2014 16:59 |
ICEM boundary condition problem | Martin_D | ANSYS Meshing & Geometry | 2 | February 14, 2011 10:20 |