CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   Mesh Generation & Pre-Processing (https://www.cfd-online.com/Forums/mesh-generation/)
-   -   Mesh (https://www.cfd-online.com/Forums/mesh-generation/181324-mesh.html)

Rodrigo_Eng_Mect December 12, 2016 11:59
Mesh
 
I am simulating ANSYS CFX centrifugal pump rotor, I use ANSYS MESHing, my logarithmic layer Y + 500 is 5.05e-3 with 20 prism cells, in ANSYS POST I check the YPlus values ​​of Inlet, Outlet between 30 and 50, however, in the region of the blades I found values ​​of Y + of 700, I tried to reduce the value of the first layer in the mesh, but with no result! What can it be? Does anyone know how I solve this problem?


All times are GMT -4. The time now is 07:37.