 |
 |
 |
|
|
|
[Sponsors] | ||||
March 20, 2017, 03:42
|
Naca 0012 mesh
|
#1 |
|
New Member
Mario Chelito
Join Date: Mar 2017
Posts: 4
Rep Power: 10  |
I Hi, could you help me with airfoil meshing. I have a problem to setup the boundary conditions. I use ICEM CFD.
I want like this: -Inlet = Only half the circle -Output= vertical side -Wall = To horizontal side But i get only like this: -Inlet = half the circle + to horizontal side -Output= vertical side -Wall = half the circle + to horizontal side Picture of mesh: https://www.google.no/search?q=airfo...zDjn7P8q2Z9NM: |
|
|
|
|
|
May 10, 2017, 23:30
|
ICEM Expert
|
#2 |
|
Member
sila
Join Date: Jul 2013
Posts: 32
Rep Power: 13 |
Hi ,
I can help you. you can send file to silambarasan7@gmail.com |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Add Mesh Layers doesnt work on the whole surface | Kryo | OpenFOAM Meshing & Mesh Conversion | 13 | February 17, 2022 07:34 |
| [ICEM] How to get a good C mesh over a NACA 0012 | aero_cfd | ANSYS Meshing & Geometry | 1 | December 23, 2016 07:32 |
| [snappyHexMesh] Snappyhex mesh: poor inlet mesh | Swagga5aur | OpenFOAM Meshing & Mesh Conversion | 1 | December 3, 2016 16:59 |
| [snappyHexMesh] Layers:problem with curvature | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 10 | August 22, 2012 09:03 |
| Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |
Linear Mode
