Cannot update new.3dm file in ICEM based on rpl file

jimmy871013 · June 20, 2017, 02:17

Dear All:

Hello~~

I am a new guy in CFD simulation. I am trying to connect rhino(3D model software) with ANSYS. I found ICEM can read .3dm file(Rhino file) so I think maybe can use rpl file to let ICEM automatic meshing my 3dm file by itself. After I did rpl file I found It can work but without update.

It means when I revise my .3dm file, ICEM cannot automatic input the same name .3dm file by itself(based on rpl file). I check the process, the ICEM always input .tin file which saved previously.So I think no matter I change the .3dm file or not, ICEM will still read the old .tin file. The automatic process seems failed. It is just my thinking maybe I am wrong.

So does anyone can give me some advise? Or maybe some export

can teach me how to set ICEM process? Or maybe someone have the same problem? Please share your ideas~~~

Thanks for anyone who pay attention to my topic~~~

Thanks a lot

Jimmy

jimmy871013 · June 20, 2017, 02:21

Thanks for anyone can pay attention to this topic~~

June 20, 2017, 02:17	Cannot update new.3dm file in ICEM based on rpl file	#1
jimmy871013 New Member Jimmy Lee Join Date: Jun 2017 Posts: 19 Rep Power: 8	Dear All: Hello~~ I am a new guy in CFD simulation. I am trying to connect rhino(3D model software) with ANSYS. I found ICEM can read .3dm file(Rhino file) so I think maybe can use rpl file to let ICEM automatic meshing my 3dm file by itself. After I did rpl file I found It can work but without update. It means when I revise my .3dm file, ICEM cannot automatic input the same name .3dm file by itself(based on rpl file). I check the process, the ICEM always input .tin file which saved previously.So I think no matter I change the .3dm file or not, ICEM will still read the old .tin file. The automatic process seems failed. It is just my thinking maybe I am wrong. So does anyone can give me some advise? Or maybe some export can teach me how to set ICEM process? Or maybe someone have the same problem? Please share your ideas~~~ Thanks for anyone who pay attention to my topic~~~ Thanks a lot Jimmy

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to calculate mass flow rate on patches and summation of that during the run?	immortality	OpenFOAM Post-Processing	104	February 16, 2021 08:46
[swak4Foam] funkyDoCalc with OF2.3 massflow	NiFl	OpenFOAM Community Contributions	14	November 25, 2020 03:30
polynomial BC	srv537	OpenFOAM Pre-Processing	4	December 3, 2016 09:07
[Other] Adding solvers from DensityBasedTurbo to foam-extend 3.0	Seroga	OpenFOAM Community Contributions	9	June 12, 2015 17:18
pisoFoam compiling error with OF 1.7.1 on MAC OSX	Greg Givogue	OpenFOAM Programming & Development	3	March 4, 2011 17:18

June 20, 2017, 02:21		#2
jimmy871013 New Member Jimmy Lee Join Date: Jun 2017 Posts: 19 Rep Power: 8	Thanks for anyone can pay attention to this topic~~