 |
 |
 |
|
|
|
[Sponsors] | ||||
Salome, wire discretization is edge discretization? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 11, 2017, 04:36
|
Salome, wire discretization is edge discretization?
|
#1 |
|
Senior Member
Oskar
Join Date: Nov 2015
Location: Poland
Posts: 184
Rep Power: 10  |
Hello. I'm trying to create sub-mesh 1D with wire discretization algorithm and number of segments hypothesis on a curved wire to create mesh similar to meshgood.png (attachment 1). Unfortunately Salome discretize every edge separately instead of entire curve as a wire like in meshbad.png (attachment 2). Can I force Salome to apply hypothesis to entire wire rather than edges?
Have a nice day. Sheaker
__________________
How to set two stroke engine with scavenging? Salome, sliding interface and "Zero length edge detected." Last edited by sheaker; August 15, 2017 at 03:24. |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
| [Salome] Export .eMesh from edge set of Salome mesh | GerhardHolzinger | OpenFOAM Meshing & Mesh Conversion | 1 | November 16, 2017 05:29 |
| Actuator disk model | audrich | FLUENT | 0 | September 21, 2009 07:06 |
| Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 01:07 |
| fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
Linear Mode
