|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Ozgur Taner
Join Date: Dec 2017
Posts: 1
Rep Power: 0 ![]() |
Hi All,
I am having problem converting a netgen mesh into OpenFoam mesh with the netgenNeutralToFoam utility. The error I receive is "attempt to ... bad file stream" it also mentions something about Line 1. I would appreciate your help in particular to these type of errors. Additionally I would also appreciate if someone experienced in netgen to openfoam mesh conversion could share some general tips on this. Thanks! |
|
![]() |
![]() |
![]() |
![]() |
#2 |
New Member
alix cattermole
Join Date: Nov 2017
Posts: 14
Rep Power: 9 ![]() |
Hello
I am currently trying to do the same as you and i am getting the exact same error. Not sure where I am going wrong. |
|
![]() |
![]() |
![]() |
Tags |
netgen, netgenmesh, netgenneutraltofoam, netgentofoam |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Snappyhex mesh: poor inlet mesh | Swagga5aur | OpenFOAM Meshing & Mesh Conversion | 1 | December 3, 2016 17:59 |
[Commercial meshers] Problems with ANSYS mesh conversion | tdog | OpenFOAM Meshing & Mesh Conversion | 1 | March 31, 2016 18:36 |
[Netgen] Netgen mesh of a geometry with a cut fails | kontra | OpenFOAM Meshing & Mesh Conversion | 0 | November 28, 2013 10:46 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 22:11 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 12:55 |