 |
 |
 |
|
|
|
[Sponsors] | ||||
September 19, 2018, 19:03
|
Meshing of micro-combustor with ICEM
|
#1 |
|
Senior Member
Weiqiang Liu
Join Date: Feb 2018
Posts: 278
Rep Power: 9  |
Hi all,
I am trying to draw the mesh of a micro combustor which is shown as follows: IMG_0042.jpg There is catalyst coated on the wall. But there is no catalyst in a very small length of the wall near the entrance, which means there is no surface reaction on this part. So how should I draw the mesh in ICEM to indicate this inert part. Thanks all. Weiqiang. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] SHIP MESHING * using ansys WORKBENCH or ICEM CFD | Ctunramran | ANSYS Meshing & Geometry | 1 | February 23, 2016 07:06 |
| [ICEM] ICEM Meshing Beginner facing problem importing file. | rrahman | ANSYS Meshing & Geometry | 0 | September 2, 2015 14:18 |
| [Gmsh] Vertex numbering is dense | KateEisenhower | OpenFOAM Meshing & Mesh Conversion | 7 | August 3, 2015 10:49 |
| [ANSYS Meshing] Issues in exporting mesh from Meshing to ICEM CFD | sihaqqi | ANSYS Meshing & Geometry | 5 | March 5, 2013 02:40 |
| [ICEM] ICEM meshing problem | xyq102296 | ANSYS Meshing & Geometry | 6 | October 28, 2010 10:09 |
Linear Mode
