|
[Sponsors] |
April 30, 2021, 10:05 |
Meshing extremely acute angled corners
|
#1 |
New Member
Meg Athadkar
Join Date: Feb 2021
Posts: 1
Rep Power: 0 |
I have a geometry of pipe intersecting a surface resulting in an extremely acute angle (tangent point & image attached). No matter how fine the element size is, this corner ends up with terrible quality cells. These cells are resulting in energy residual divergence.
Could anyone provide their opinion on how to sort this? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Meshing thin and extremely long insulated pipe | Y27 | STAR-CCM+ | 2 | September 17, 2020 07:16 |
[ANSYS Meshing] 2D Meshing of Parallel Airfoils | Fco.Herbert | ANSYS Meshing & Geometry | 1 | December 5, 2017 15:42 |
[ANSYS Meshing] meshing extremely slow | dynamic | ANSYS Meshing & Geometry | 3 | February 15, 2017 05:11 |
[ANSYS Meshing] Meshing cuboidal room with openings | nickdaish | ANSYS Meshing & Geometry | 6 | February 21, 2015 11:17 |
Meshing sharp corners - mesh for a MVG | fportela | Mesh Generation & Pre-Processing | 0 | March 17, 2013 11:33 |