Home > Forums > Special Topics > Mesh Generation & Pre-Processing

What is a best practice to reduced number of iteration for steady simulation?

Updated Threads

Reply

Search this Thread

May 19, 2021, 14:25	What is a best practice to reduced number of iteration for steady simulation?	#1
AbhishekShingalaCFD New Member Abhishek Join Date: Sep 2020 Location: Magdeburg, Germany Posts: 10 Rep Power: 5	I am performing steady flow simulation of a radial pump, which takes around 400,000 iterations to give satisfactory results (compared to experimental values). Now there is a need of testing many operating points and thus I need to run many simulations, which cost a lot of simulation time. How can I achieve accurate results faster? -by refining mesh in particular zone, tweaking with initial values!!!! or!!!

Reply

Tags

accuracy, best practice, iterations increase, mesh

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[General] Extracting ParaView Data into Python Arrays	Jeffzda	ParaView	30	November 6, 2023 21:00
Foam::error::PrintStack	almir	OpenFOAM Running, Solving & CFD	91	December 21, 2022 04:50
[snappyHexMesh] SnappyHexMesh running killed!	Mark JIN	OpenFOAM Meshing & Mesh Conversion	7	June 14, 2022 01:37
Inconsistencies in reading .dat file during run time in new injection model	Scram_1	OpenFOAM	0	March 23, 2018 22:29
[snappyHexMesh] No layers in a small gap	bobburnquist	OpenFOAM Meshing & Mesh Conversion	6	August 26, 2015 09:38

All times are GMT -4. The time now is 11:35.