Mesh Generation with TurboGrid
Hi to everyone,
I am meshing a centrifugal fan with TurboGrid. The trailing and leading edges have a cut off, therefore I have included this feature in the geometric representation of the blade. However I get this error: The selected topology templates did not result in a valid topology. Please refer to the following messages for more details: Thread 1 failed at index 1 with message: Round off problems. Last Edge length too small=1.41101e-08, #of segments 51 Can anyone understand what it means? Thanks in advance, Mauro |
All times are GMT -4. The time now is 19:57. |