|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Join Date: Nov 2020
Posts: 3
Rep Power: 4 ![]() |
Hi to everyone,
I am meshing a centrifugal fan with TurboGrid. The trailing and leading edges have a cut off, therefore I have included this feature in the geometric representation of the blade. However I get this error: The selected topology templates did not result in a valid topology. Please refer to the following messages for more details: Thread 1 failed at index 1 with message: Round off problems. Last Edge length too small=1.41101e-08, #of segments 51 Can anyone understand what it means? Thanks in advance, Mauro |
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
foam-extend-4.1 release | hjasak | OpenFOAM Announcements from Other Sources | 19 | July 16, 2021 05:02 |
GeometricField -> mesh() Function | Tobi | OpenFOAM Programming & Development | 10 | November 19, 2020 11:33 |
Mesh motion with Translation & Rotation | Doginal | CFX | 2 | January 12, 2014 06:21 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |