 |
 |
 |
|
|
|
[Sponsors] | ||||
October 29, 2022, 17:20
|
Programming mesh connectivity
|
#1 |
|
Senior Member
Daniel
Join Date: Feb 2017
Location: Germany
Posts: 147
Rep Power: 9  |
Hello,
I was wondering, how to implement mesh connectivity or element ID into a meshing program, to check wether the element is an interior or boundary cell or even more important how many faces of the element are connected to a boundary wall. Is there s popular way of doing this ? Would appreciate any hints, or eventually exemplary code. Thanks for any help! |
|
|
|
|
|
October 31, 2022, 04:06
|
|
#2 |
|
Senior Member
Daniel
Join Date: Feb 2017
Location: Germany
Posts: 147
Rep Power: 9 |
Found a good way in the book "The Finite Volume Method in Computational Fluid Dynamics" by Moukalled.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| foam-extend-4.1 release | hjasak | OpenFOAM Announcements from Other Sources | 19 | July 16, 2021 05:02 |
| GeometricField -> mesh() Function | Tobi | OpenFOAM Programming & Development | 10 | November 19, 2020 11:33 |
| [ICEM] 2D hybrid mesh (unstructured mesh highly dependent on structured mesh parameters) | shubham jain | ANSYS Meshing & Geometry | 1 | April 10, 2017 05:03 |
| [ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
| [Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |
Linear Mode
