 |
 |
 |
|
|
|
[Sponsors] | ||||
September 27, 2022, 05:48
|
Mesh axisymmetric body ICEM CFD
|
#1 |
|
New Member
Antimo
Join Date: Sep 2022
Posts: 6
Rep Power: 3  |
Hello everybody,
I try to do a structured mesh body in the figure with ICEM CFD, but I find a lots problems, All attempts I have a problem with a negative volume and the quality of mesh is too bad to run in Fluent. I try with 3D blocking but it'is very difficult to have a good mesh, then I try to extrude a 2D mesh but the results is not changed, I don't have a big experience with mesh, do you have any suggestions? Thanks for any help!! |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] How to generate an unstructured mesh for a 2 fluid domain rotor in ICEM CFD | Hazem24 | ANSYS Meshing & Geometry | 0 | December 21, 2020 06:52 |
| [mesh manipulation] Importing Multiple Meshes | thomasnwalshiii | OpenFOAM Meshing & Mesh Conversion | 18 | December 19, 2015 18:57 |
| Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
| Imported ICEM mesh has additional body in the mesh | Procyon | CFX | 1 | January 27, 2011 16:21 |
| fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
Linear Mode
