Home > Forums > Special Topics > Mesh Generation & Pre-Processing

Exporting mesh from ANSA

Mark Forums Read

Reply

Search this Thread

January 18, 2024, 16:02	Exporting mesh from ANSA	#1
Ahmad.s New Member Ahmad Saleh Join Date: Nov 2023 Posts: 1 Rep Power: 0	Hello everyone I created mesh in ICEM and also created a mixed type mesh in ANSA. I want to export the mesh from ANSA to ICEM for merging, but I couldn't. Any suggestions on exporting mesh from ANSA to ICEM please?

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] non uniform mesh near the stl object	vava10	OpenFOAM Meshing & Mesh Conversion	0	January 31, 2021 15:41
[ICEM] Problem with exporting mesh after smoothing	Wroobs	ANSYS Meshing & Geometry	2	January 4, 2018 17:12
Using Ansa for Mesh generation	CellZone	ANSA	1	July 7, 2017 06:30
[snappyHexMesh] No layers in a small gap	bobburnquist	OpenFOAM Meshing & Mesh Conversion	6	August 26, 2015 10:38
[snappyHexMesh] Layers:problem with curvature	giulio.topazio	OpenFOAM Meshing & Mesh Conversion	10	August 22, 2012 10:03

All times are GMT -4. The time now is 19:11.