CFD Online Discussion Forums

CFD Online Discussion Forums (
-   NUMECA (
-   -   Parallel Simulation Numeca Fine (

daxterss July 27, 2012 03:33

Parallel Simulation Numeca Fine

I am trying to run a simulation with a parallel computation. My computer has 4 cores. I open the Task Definition Window and I activate the option parallel computation and when I try to run it, a window appear and is like is going to start but the simulation doesn't start. This windows shows "start_status_ok" but the simulation doesn't run.

Can anybody help me?? Thanks in advance

daxterss July 27, 2012 03:46

More information: I use Windows 64 bits... can be because of the system??

oldshoes81 July 30, 2012 01:37


Could i know what version of NUMECA FINE you are using and what type of Windows you have?

Before you could do so, you will have to make sure that your license does support for multi-cores up to 4 cores (for your case). Secondly, if the license does meet your requirement, make sure you register the MPIregister.exe and wpiregister.exe (in \bin directory) and key in your username and password that you use to log in the windows. if you do not have one, please create it.

Lastly, make sure the smpd.exe is pointed from /bin64.

I will encourage you to reach to your local support as the set up may a bit complicated.

daxterss July 31, 2012 07:36

Thanks a lot!!!
It is working now!! :))

daxterss September 11, 2012 07:45

Hello again
I would like to run the simlation in LINUX now... but there is a problem and I can't.
Anybody knows how i can use "ssh" instead of "rsh" (it is by default this last one)
Thanks in advance

oldshoes81 September 11, 2012 22:00


Anyway you could reach to your local support on this manner? I believe they will happy to help you. By the way, may i know where are you located?

micalcheung June 24, 2013 04:52

I have the same problem with you
I wanna know how did you solve the problem
could you do me a favor ?
thanks a lot

All times are GMT -4. The time now is 18:33.