 |
 |
 |
|
|
|
[Sponsors] | ||||
September 7, 2012, 04:06
|
Question about 'negative cell'
|
#1 |
|
Senior Member
Meimei Wang
Join Date: Jul 2012
Posts: 494
Rep Power: 15  |
Hi,
May I ask what does 'negative cell' mean in Autogrid?
__________________
Best regards, Meimei |
|
|
|
|
|
September 11, 2012, 22:01
|
|
#2 |
|
Member
CJ
Join Date: Apr 2010
Location: Malaysia
Posts: 69
Rep Power: 16   |
Hi Anna,
It is a so call "negative volume" cell. The cell must have been distorted due to the compression.
__________________
Regards CJ NUMIT Enterprise, Malaysia +6 017 656 3436 http://maccom-numit.blogspot.com http://www.numit.com.my Email : seiko.q@numit.com.my |
|
|
|
|
|
|
September 12, 2012, 04:11
|
|
#3 | |
|
Senior Member
Meimei Wang
Join Date: Jul 2012
Posts: 494
Rep Power: 15 |
Quote:
__________________
Best regards, Meimei |
||
|
|
|
||
|
September 12, 2012, 04:46
|
|
#4 |
|
Member
CJ
Join Date: Apr 2010
Location: Malaysia
Posts: 69
Rep Power: 16 |
Hi Anna,
When you have too many mesh within your domain, the domain may not been seem to allocate more mesh and if you insist to increase the cell, this will tend to deform the mesh.
__________________
Regards CJ NUMIT Enterprise, Malaysia +6 017 656 3436 http://maccom-numit.blogspot.com http://www.numit.com.my Email : seiko.q@numit.com.my |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| gradient calculation in ghost cell for the cell-centered finite volume method | legend | Main CFD Forum | 4 | March 11, 2014 10:40 |
| Simple manual cell deleting question | jasimpson89 | OpenFOAM Pre-Processing | 9 | June 20, 2012 11:20 |
| Cells with t below lower limit | Purushothama | Siemens | 2 | May 31, 2010 21:58 |
| [blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |
| negative cell volume in dynamic mesh | WU zhonghua | FLUENT | 0 | July 28, 2004 10:04 |
Linear Mode
