guidance for correcting results for a variable geomerty radial turbine.
 

Hello,

I am working on a variable geometry radial turbine in numeca and i need some help to let me know if the results are correct are not,I will be posting them soon if needed, Or it would also be nice to know about what should be expected.
The Radial turbine is tested with a speed range of 90 - 130 krpm with a varying hub clearance of 2%- 4% 6%8% and 10% of 7mm.
I do understand as to what could the consequences in a theoretical point of view but i do not understand what to expect from the results seen in the software.
Any suggestions or reading material would be very helpful.

Thank You :)