CFD Online Discussion Forums - Problem with generating and meshing T.E of rotor

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)

- Fidelity CFD (https://www.cfd-online.com/Forums/fidelity-cfd/)

- - Problem with generating and meshing T.E of rotor (https://www.cfd-online.com/Forums/fidelity-cfd/119886-problem-generating-meshing-t-e-rotor.html)

nischithreddy92

June 26, 2013 10:46

Problem with generating and meshing T.E of rotor

Hii all,
I am working on the tool Numeca Autogrid 5 and im finding a problem to model and mesh the trailing edge slot of the rotor,the rotor is very curved and its difficult to model but the customer insists,so please help by giving any valid procedure for modeling the same.

Thanks in advance

oldshoes81

June 27, 2013 03:38

Hi,

Check if you have used the correct template. If the sharp edge creates the trouble, force it to ROUND edge.

Hamidzoka

June 28, 2013 04:06

Could you leave a geometry of your airfoil at TE ?

All times are GMT -4. The time now is 01:32.