 |
 |
 |
|
|
|
[Sponsors] | ||||
Problem with generating and meshing T.E of rotor |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 26, 2013, 10:46
|
Problem with generating and meshing T.E of rotor
|
#1 |
|
New Member
cfd enthusiasist
Join Date: Jun 2013
Posts: 1
Rep Power: 0  |
Hii all,
I am working on the tool Numeca Autogrid 5 and im finding a problem to model and mesh the trailing edge slot of the rotor,the rotor is very curved and its difficult to model but the customer insists,so please help by giving any valid procedure for modeling the same. Thanks in advance |
|
|
|
|
|
June 27, 2013, 03:38
|
|
#2 |
|
Member
CJ
Join Date: Apr 2010
Location: Malaysia
Posts: 69
Rep Power: 15   |
Hi,
Check if you have used the correct template. If the sharp edge creates the trouble, force it to ROUND edge.
__________________
Regards CJ NUMIT Enterprise, Malaysia +6 017 656 3436 http://maccom-numit.blogspot.com http://www.numit.com.my Email : seiko.q@numit.com.my |
|
|
|
|
|
|
June 28, 2013, 04:06
|
|
#3 |
|
Senior Member
Hamid Zoka
Join Date: Nov 2009
Posts: 282
Rep Power: 18 |
Could you leave a geometry of your airfoil at TE ?
|
|
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem with querying the meshing database in CFX-Pre | ashtonJ | CFX | 18 | April 18, 2023 23:49 |
| [ANSYS Meshing] ICEM Meshing problem | drvincentip | ANSYS Meshing & Geometry | 1 | May 2, 2013 17:31 |
| Meshing problem with ansys default mesher | wh88 | ANSYS | 5 | October 5, 2011 16:27 |
| Catalogue size problem but while meshing! | Jo Bouchard | CFX | 2 | December 28, 2005 11:32 |
Linear Mode
