 |
 |
 |
|
|
|
[Sponsors] | ||||
October 15, 2013, 08:32
|
Out put
|
#1 |
|
New Member
abas abas
Join Date: Oct 2013
Posts: 1
Rep Power: 0  |
Excuse me, I'm very new in numeca and I want to give a Pressure distribution on a blade!
like this  I want to get this for 5 sections, 0 , 0.25, 0,75, 0.9, 1 Can anyone help me?!  Thank you every one Last edited by Abas; October 23, 2013 at 10:54. |
|
|
|
|
|
December 6, 2013, 04:44
|
|
#2 |
|
Member
CJ
Join Date: Apr 2010
Location: Malaysia
Posts: 69
Rep Power: 15   |
Hi,
Try to just the control point at OUTPUT page.
__________________
Regards CJ NUMIT Enterprise, Malaysia +6 017 656 3436 http://maccom-numit.blogspot.com http://www.numit.com.my Email : seiko.q@numit.com.my |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Taking advantage of GCCbs profilearcs optimization | connclark | OpenFOAM Installation | 2 | June 29, 2007 14:11 |
Linear Mode
