|January 7, 2014, 08:10||
Hexpress: Refinement Box definition
Join Date: Mar 2009
Posts: 7Rep Power: 10
defining a refinement box in the domain by clicking two corner points on the
screen is in some occasions not very convenient when you want
to have your box at a specific location.
Are there alternative ways for definition by typing the coordinates
of the two corner points?
Or even better import an stl-file that defines the refinement region?
|January 16, 2014, 11:18||
Join Date: May 2012
Posts: 67Rep Power: 6
When you have selected to create a new box, you can left-click in the section at the bottom (just below the black bar) that indicates: Enter >>
With the cursor in this line you can then type the x y and z coordinates separated by a blank space and confirmed by pressing Enter. Then you can type the coordinates of the second point in the same way.
Alternatively you could write a tiny macro containing the command:
create_refinement_cube(x1, y1, z1, x2, y2, z2)
but probably through the GUI on the Enter line is easiest.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Adding layers goes wrong with SnappyHexMesh||Elise||OpenFOAM Native Meshers: snappyHexMesh and Others||1||April 22, 2013 02:32|
|snappyHexMesh refinement regions ignored||guitarbren||OpenFOAM Meshing & Mesh Conversion||2||April 9, 2013 03:59|
|killed "snappyHexMesh"||parkh32||OpenFOAM Pre-Processing||2||April 8, 2012 17:12|
|OpenFOAM static build on Cray XT5||asaijo||OpenFOAM Installation||9||April 6, 2011 12:21|
|snappyHexMesh aborting||Tobi||OpenFOAM Native Meshers: snappyHexMesh and Others||0||November 10, 2010 04:23|