|
[Sponsors] |
May 13, 2014, 00:12 |
Number of refinement
|
#1 |
New Member
Amirah
Join Date: Jan 2014
Posts: 7
Rep Power: 12 |
Hello,
May anyone help me. I want to know if I change the number of refinement, did I need to change the other setting also..???.. I want to reduce the number of refinement because my laptop unable to support a large number of refinement. But when I do so there will be error where hole been detected. Thank you. |
|
May 15, 2014, 17:23 |
|
#2 |
Senior Member
Hamid Zoka
Join Date: Nov 2009
Posts: 282
Rep Power: 18 |
refinement increases the chance of successful meshing.
depending on the geometry, a certain level of refinement is needed to avoid the holes inside the domain. one solution is to confine the refinement only to critical regions and for other regions keep the element size as big as possible. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
AMI speed performance | danny123 | OpenFOAM | 21 | October 24, 2020 05:13 |
simpleFoam parallel | AndrewMortimer | OpenFOAM Running, Solving & CFD | 12 | August 7, 2015 19:45 |
[snappyHexMesh] Edge refinement | ashghan | OpenFOAM Meshing & Mesh Conversion | 4 | May 13, 2014 06:45 |
snappyHexMesh in parallel - FOAM Fatal IO Error | mturcios777 | OpenFOAM Running, Solving & CFD | 4 | August 10, 2012 20:18 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 05:15 |