Propeller mesh problem for Autogrid 5

Johnson Shi · April 28, 2014, 12:51

Hello, CFD friends

Recently, when I use geomturbo file to generate propeller mesh by using Autogrid 5, very twisted mesh happens at the tip region. I have tried to increase the accuracy of the data file. It turned out to be no use.

Only if I increase the chord length, this problem can be fixed. However this is not the right thing I can do.

The picture is showing like below. Please help me

razi.me05 · July 21, 2014, 02:54

Hi Johnson,
Can you please tell me if you could solve the problem. I'm stuck with the same kind of problem.
I'd really appreciate your help.

Pierre-Alain · August 9, 2014, 03:56

Good Morning,

It seems the skewed mesh observed on the pictures of the initial post is due to a distorted leading edge geometry. I would advice to review the leading edge shape in case the same issue is encountered. Mesh generation of aircraft or marine propellers is usually quite straightforward with AutoGrid5. Especially with the wizard.

Regards.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Dynamic Mesh Problem.	Tom Clark	FLUENT	10	June 21, 2021 04:27
Moving mesh	Niklas Wikstrom (Wikstrom)	OpenFOAM Running, Solving & CFD	122	June 15, 2014 06:20
[GAMBIT] SOFC crossflow mesh possible problem???	epc1	ANSYS Meshing & Geometry	1	February 4, 2013 01:57
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 21:11
Moving mesh problem	Geon-Hong	FLUENT	3	April 5, 2010 03:24

July 21, 2014, 02:54		#2
razi.me05 Member Nevada Join Date: Apr 2014 Posts: 32 Rep Power: 11	Hi Johnson, Can you please tell me if you could solve the problem. I'm stuck with the same kind of problem. I'd really appreciate your help.

August 9, 2014, 03:56		#3
Pierre-Alain New Member Pierre-Alain Join Date: Aug 2014 Posts: 4 Rep Power: 11	Good Morning, It seems the skewed mesh observed on the pictures of the initial post is due to a distorted leading edge geometry. I would advice to review the leading edge shape in case the same issue is encountered. Mesh generation of aircraft or marine propellers is usually quite straightforward with AutoGrid5. Especially with the wizard. Regards.