How to adjust toggle vertice of 3D block in IGG other than manual adjustment?

hangyufenfei · June 11, 2015, 10:52

hello guys, I want to mesh a 3D geometry in IGG software, and I created 3D block according to the topology of the geometry. But some of the toggle vertices of 3D block were not positioned suitablely, and I want to adjust their positions. Are there any way other than manual adjustment?

tdrerwann · June 19, 2015, 03:55

Hello,

To adjust position of toggle vertices in IGG you can use a script file. You may find more details in the documentation of IGG.
The easiest way in your case would be to record your manual adjustment once (from the interface, File/Scripts/Record) and then have a look at the script file you have created to better understand the structure of it (details of the commands are given in the documentation).
Finally, you will be able to modify the script at your convenience and execute it to avoid extra manual adjustment.

I hope this might help.

Regards,
Erwann

June 11, 2015, 10:52	How to adjust toggle vertice of 3D block in IGG other than manual adjustment?	#1
hangyufenfei New Member 航之梦 Join Date: May 2015 Posts: 1 Rep Power: 0	hello guys, I want to mesh a 3D geometry in IGG software, and I created 3D block according to the topology of the geometry. But some of the toggle vertices of 3D block were not positioned suitablely, and I want to adjust their positions. Are there any way other than manual adjustment?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[blockMesh] Mixer mesh - negative volume problem	jadtwo	OpenFOAM Meshing & Mesh Conversion	2	November 6, 2014 16:37
foamLog not solving for Ux, Uy, Uz	aerospain	OpenFOAM Post-Processing	5	April 18, 2012 10:01
[Commercial meshers] Icem Mesh to Foam	jphandrigan	OpenFOAM Meshing & Mesh Conversion	4	March 9, 2010 02:58

June 19, 2015, 03:55		#2
tdrerwann New Member Erwann Join Date: Feb 2015 Posts: 7 Rep Power: 11	Hello, To adjust position of toggle vertices in IGG you can use a script file. You may find more details in the documentation of IGG. The easiest way in your case would be to record your manual adjustment once (from the interface, File/Scripts/Record) and then have a look at the script file you have created to better understand the structure of it (details of the commands are given in the documentation). Finally, you will be able to modify the script at your convenience and execute it to avoid extra manual adjustment. I hope this might help. Regards, Erwann