|
[Sponsors] |
November 30, 2016, 20:46 |
Error when parallel computing
|
#1 |
New Member
shaodong
Join Date: Jun 2013
Posts: 4
Rep Power: 12 |
Hi,all!
I have a problem that FINE could run with single core, but didn't run !stack error: Space already allocated fornmbufpwith parallel computing. The error showed as blow and FINE stopped: In my model,there is 4 FNMB between the cavity and main passage of centrifugal compressor.
Is that related to the problem? I can post the pic of my model in detail if necessary. Thank you! |
|
December 27, 2016, 09:39 |
|
#2 |
Senior Member
Hamid Zoka
Join Date: Nov 2009
Posts: 282
Rep Power: 18 |
Hi
check if it runs in parallel in case of a very simple case. Non matching boundaries sometimes bring about some difficulties! Regards |
|
April 11, 2017, 04:54 |
|
#3 |
Senior Member
Colinda
Join Date: May 2012
Location: Brussels
Posts: 151
Rep Power: 13 |
Is the problem solved in the meanwhile?
If the case runs in serial and not in parallel it sounds to me like a defect and should be investigated in further detail. Even if it is caused by a wrong project set-up the error message should give a more clear indication of what is wrong. Even if a very simple case would run in parallel, it would still not provide any indication for the reason why your specific case would not work. And very often it is not desirable or possible to avoid non-matching boundaries. Many users are running cases with non-matching boundaries in parallel. In principle this should not be a problem at all. If you have access to hotline support, I would recommend to have this investigated through the regular support channel. Best regards, Colinda |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Parallel computing on a personal workstation | choiyun | STAR-CCM+ | 6 | April 10, 2017 09:58 |
Explicitly filtered LES | saeedi | Main CFD Forum | 16 | October 14, 2015 11:58 |
simpleFoam parallel | AndrewMortimer | OpenFOAM Running, Solving & CFD | 12 | August 7, 2015 18:45 |
Parallel Computing | peter | Main CFD Forum | 7 | May 15, 2006 09:53 |
Parallel Computing Classes at San Diego Supercomputer Center Jan. 20-22 | Amitava Majumdar | Main CFD Forum | 0 | January 5, 1999 12:00 |