Solver crashed
 

Hi all

I'm a naval architecture student and new comer of Fine/Marine software. I'm currently perform simulation of 3D drop object of ship. However, I found problem that I need to ask. Since yesterday when I run it, it has massage on Fine task manager "No new results are available." and the solver is crashed.
what should I check when I had that problem.?

Thank you

hello,

I'm trying to do the tutorial exercises. however, I launch the calculation, the solver crashed.
the exercise is the first of the tutorials found on the net, driven_cavity.

can you tell what is my simply problem?

thanks

Hello, i have run a solver, in parallel and also in serial mode, but i obtain the same results.
Solver crashed :confuso: after 5078 cycle, can you tell me what is the problem?
i have launch a simple simulation, bare hull, resistance at 10kn, mesh report ok.

thank you in advance