CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   NUMECA (https://www.cfd-online.com/Forums/numeca/)
-   -   plotting quantities in theta direction at particular radius (https://www.cfd-online.com/Forums/numeca/221476-plotting-quantities-theta-direction-particular-radius.html)

navjot October 18, 2019 03:19

plotting quantities in theta direction at particular radius
 
Hi,

I was trying to plot theta vs static pressure to see how static pressure is varying at the inlet of the blade at a particular span location ( 95% span) along the circumferential direction in CFView. I am running an unsteady case for 360 degrees simulation for an axial compressor.

I had tried to cut a section at the blade leading edge and then plot the static pressure at the section, then exported the active surface quantities and, wrote a code for plotting theta vs static pressure. The plotted data is not giving any solid conclusion about how static pressure is varying due to the approximation of radius.

Is there is any easy way to plot in CFView theta vs quantity at a particular radius of a section?

thanking you,

Navjot Joshi
IIT bombay


All times are GMT -4. The time now is 23:42.