|
[Sponsors] |
June 1, 2021, 03:54 |
How cut plane to many small annular planes?
|
#1 |
New Member
wwcs
Join Date: May 2021
Posts: 4
Rep Power: 4 |
[For CFView]In a axial flow,the single flow passage may be a sectorial plane.Now I want cut it by different radius range(like 0.1-0.2,0.2-0.3....) to many small annular palnes. How can I do it?
I have tried iso-surface,but it create surface like B to B surface.Cuting plane or split surface in Geometry also no use. I know that it can easily do it in Fluent,but I can't relize it in CFview |
|
June 9, 2021, 05:06 |
|
#2 |
New Member
Alban
Join Date: Sep 2019
Posts: 7
Rep Power: 6 |
Dear Abuya,
All the 3D views (cartesian, cylindrical and STM) are linked. If you create a surface in any of them, it will be available in the others. In your case, you can create a surface in any of the view and use the split surface (Geometry/Split surface...) in the cylindrical view for extracting an annular surface as you can see below: This gives the following in the 3D view: The grey surface is the original cut and the red one is the annular section extracted from the cut. Does it correspond to what you are looking for? Thank you. Best regards, Alban |
|
June 15, 2021, 23:47 |
|
#3 | |
New Member
wwcs
Join Date: May 2021
Posts: 4
Rep Power: 4 |
Quote:
|
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Some surfaces are not cut ('segment by plane') [+ image] | DeadLee | ANSYS Meshing & Geometry | 2 | October 14, 2020 17:34 |
[Commercial meshers] faceSet of a cutting plane for a internal patch definition | RubenGutiii | OpenFOAM Meshing & Mesh Conversion | 1 | April 17, 2019 05:10 |
[snappyHexMesh] .STL: non-closed manifold surface | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 32 | November 25, 2016 03:15 |
Plane stress and plane strain cases for stress analysis | Sargam05 | OpenFOAM | 0 | May 3, 2013 18:16 |
How can I get the small plane in the polyline on the large plane? | Aisun | CFX | 1 | August 8, 2012 03:38 |