reference pressure in Numeca
Hey, guys. I'm learning Numeca recently. I have a question about the reference pressure in Numeca. What is the meaning of it? If the reference pressure is 1atm, and the inlet total pressure is 2atm. Should I set the inlet total pressure to be 1atm (2atm-1atm) or 2atm?
|
Hi;
In NUMECA Boundary values for pressure are absolute values and do not need to be expressed with respect to reference pressure. The function of the mentioned reference pressure,together with reference temperature, is to calculate entropy and its value does not affect the results. As it is known, entropy is always measured with respect to a reference value and in thermodynamic processes its delta is important. So, These reference parameters can take any value. Regards |
Quote:
|
I would like to add that apart from the entropy, the reference pressure is used at other places as well. This may be different for each solver. For example for the Fine™/Turbo solver this may be:
It is also used as a default gauge pressure for the preconditioning in case of low speed or incompressible flows. |
All times are GMT -4. The time now is 20:14. |