Omnis: Monitoring mass flow rate in the convergence monitor

Johan M · February 1, 2022, 07:44

Hi everyone! I am a new Numeca using that has started learning Omnis. I am running a pipe simulation and wished to monitor the mass flow rate at the inlet and outlet of the pipe. The option for Mass flow out/in did not seem to display under the Physical quantities option, as seen in the attached image. Does anyone happen to know why it is not available? Apologies if this is a basic question. Thanks

Johan M · February 4, 2022, 07:24

Apologies, I had not selected the Internal flow option, which prevented me from monitoring the mass flow

February 4, 2022, 07:24		#2
Johan M New Member Johan M Join Date: May 2021 Posts: 25 Rep Power: 4	Apologies, I had not selected the Internal flow option, which prevented me from monitoring the mass flow colinda1 likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
axial compressor mass flow convergence issue	jyotir	SU2	4	November 24, 2021 06:03
Monitoring Mass Flow Rate	Umuteng	SU2	5	February 17, 2019 18:17
mass flow in is not equal to mass flow out	saii	CFX	12	March 19, 2018 05:21
Uniform mass flow rate at different outlets.	mehcaecfd	STAR-CCM+	6	May 18, 2016 02:34
Periodic channel flow with time dependent mass flow rate	QBeast	FLUENT	3	May 10, 2013 13:14