Stitching volumes
 

I am currently drawing a race car in Gambit with a wind tunnel around the car. I am having trouble stitching the faces together to form a volume to mesh for the car and wind tunnel. It comes up with an error message saying the faces have edges which cant be connected. How can I get round this problem? Is it because my faces are virtual faces?

Re: Stitching volumes
 

Hello Jimmy,

As you've posted your question in the NUMECA forum, can I assume that you are manipulating a mesh from HEXPRESS? Merging faces is quite easy to do in HEXPRESS, and I would recommend following our tutorials to learn the technique. If you still run into problems, please feel free to send the geometry to your local support office for detailed feedback.

Best regards, Allan