Hi, Every one,

I have problem in using Numeca60, The technique supporter in our country can't resolve the problem, who can answer me? Thanks lots.

The messages in MSDOS window when I start the IGG are list in the follows,

" CONFIG 4 CONFIG 4

CONFIG but_3d

CONFIG blockBut CONFIG 1 3 4 HDriver type : WOGL version : 2.24 planes : 24 colors : 16777216 max colors : 16777216 z buffer depth : 0 hard cutting planes: 0 hard lights : 1 hard gouraud : yes hard phong : no width : -1 cm height : -1 cm aspect ratio : -1 max width : 32 cm max height : 24 cm width resolution : 32 px/cm height resolution : 32 px/cm

'import site' failed; use -v for traceback ->STL:Tool:GroupSelector:updateGroups ->STL:Tool:GroupSelector:updateGroups HOOPS information (2,2)

There was an unexpected Hoops internal error -

You must name either a particular family member or

a particular Aheight to Mark-System-Default

"

regards

Bob Hahry

That sounds ugly. Might want to try changing from the default graphics driver - don't know if this info is in the manual or not though.

I'm curious - what country are you in?

John

Dear Bob,

We have been unable to find any record of your support request to any of our worldwide offices. Please send an E-mail directly to support@numeca.be, stating your company name and referring to this issue.

Best regards, Allan