Autogrid

August 11, 2003, 14:51

Hi,

Just a little question about autogrid v4.4. How can I easily export, in an ascci format, the meridional mesh in cylindrical coordinates ?

Thanks in advance

August 19, 2003, 10:36

Dear ked?

You can export every selected face, patch or block from AUTOGRID(tm)4.7-x via the menue FILE -> EXPORT -> Face coor | Block coor | Patch coor to an ascii file.

To convert the cartesian coordinates to cylindrical ones, you can use IGG(tm)4.7-x (Menue FILE -> Convert Data -> Cartesian_Cylindrical).

If you don´t have this version, please contact your support team.

Best regards

Peter

August 11, 2003, 14:51	Autogrid	#1
ked Guest Posts: n/a	Hi, Just a little question about autogrid v4.4. How can I easily export, in an ascci format, the meridional mesh in cylindrical coordinates ? Thanks in advance

August 19, 2003, 10:36	Re: Autogrid	#2
Peter Thiel Guest Posts: n/a	Dear ked? You can export every selected face, patch or block from AUTOGRID(tm)4.7-x via the menue FILE -> EXPORT -> Face coor \| Block coor \| Patch coor to an ascii file. To convert the cartesian coordinates to cylindrical ones, you can use IGG(tm)4.7-x (Menue FILE -> Convert Data -> Cartesian_Cylindrical). If you don´t have this version, please contact your support team. Best regards Peter

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Autogrid: discontinuity of 90 degrees in shroud	Eric Joubarne	Fidelity CFD	1	July 21, 2009 04:34
autogrid:leading edge	liu wangkou	Fidelity CFD	2	August 22, 2008 19:42
HELP ME!!! I cannot import blade in autogrid!	Nicola	Fidelity CFD	2	February 1, 2008 03:38
AUTOGRID and AUTOBLADE strengths and limitations	Haider	Fidelity CFD	1	December 6, 2007 20:24
About the using of AutoGrid 5	Wheeler	Fidelity CFD	0	November 5, 2005 07:05