The radial stator-rotor seal

April 7, 2008, 21:27

I'm concerned about the radial rotor-stator seal and clapboard seal flow,How to establish the seal model in a completed turbine stage in the NUMECA software?Thank you very much!

August 22, 2008, 19:48

what is the clapboard seal? if it is an axisymmetric geometry outside the meridional channel limits, but obviously connected to the stage at certain regions... you can mesh that with AutoGrid5... it is the so called meridional or ZR-effect. It is possible to define RS interface in the zr-effects as well.

April 7, 2008, 21:27	The radial stator-rotor seal	#1
liu wangkou Guest Posts: n/a	I'm concerned about the radial rotor-stator seal and clapboard seal flow,How to establish the seal model in a completed turbine stage in the NUMECA software?Thank you very much!

August 22, 2008, 19:48	Re: The radial stator-rotor seal	#2
arthur Guest Posts: n/a	what is the clapboard seal? if it is an axisymmetric geometry outside the meridional channel limits, but obviously connected to the stage at certain regions... you can mesh that with AutoGrid5... it is the so called meridional or ZR-effect. It is possible to define RS interface in the zr-effects as well.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
rotor stator	Amir Jourak	CFX	2	July 6, 2007 09:51
rotor/stator	gador	CFX	2	January 17, 2005 17:00
rotor-stator interaction	Mukkarum	FLUENT	0	February 25, 2004 02:44
Stator/Rotor interface of a radial compressor	mohamed	CFX	1	September 20, 2000 06:45
Stator & Rotor interaction	ghlee	Main CFD Forum	3	September 9, 1998 11:56