|March 17, 2010, 14:04||
History Convergence: Graphical problem
Join Date: May 2009
Posts: 22Rep Power: 9
I'm working with fine/turbo 8.6-1 on turbomachinery. I've launched a calculation with 1500 iterations. With Monitor I've plotted my history convergence curve and I've seen the calculation required more iterations in order to attain convergence.
In order to continue the calculation I've avoided to delete the history convergence and I launched the calculation from the previous run file.
Here comes my problem. When I launch Monitor to check the history convergence curve I obtain graphical bugs and a amount of lines but there is no more curves.....And it's clearly a graphical problem (i've already checked if it wasn't a divergence).
I would like to know if it's a known issue or did i make something wrong? I hope that someone could bring me some elements to solve this annoying problem.
|March 18, 2010, 00:40||
Join Date: Nov 2009
Posts: 206Rep Power: 11
what do you mean by "amount of lines but there is no more curves" ?
can you clearly describe it?
what about history of convergence curve inside the FINE? deos it have a simliar behavoir to what MONITOR shows? or it is normal?
can you see the convergence curve in FINE when you restart the calculations? is it updated as the iterative solution goes on?
FINE and MONITOR convergence curves should show an identical trend.
check this and come back again.
|Thread||Thread Starter||Forum||Replies||Last Post|
|convergence problem||commonyue||Main CFD Forum||1||December 1, 2009 04:54|
|Submerged fin, Convergence problem||supermouniette||FLUENT||10||July 6, 2009 10:47|
|Convergence of CFX field in FSI analysis||nasdak||CFX||2||June 29, 2009 01:17|
|3D Fluid Flow Convergence problem||Emily||FLUENT||2||March 21, 2007 23:18|
|Non Convergence of 3D Heat transfer cfd problem||Balraj||Main CFD Forum||3||December 9, 2004 01:24|