|
[Sponsors] |
December 13, 2018, 10:41 |
twoPhaseEulerFoam rotating machinery
|
#1 |
New Member
Join Date: Dec 2018
Posts: 1
Rep Power: 0 |
Hi foamers ,
i'm new in openFOAM, i have to simulate a two phase (water-air) flow through a rotating machinery. I've started from the bubbleColumn tutorial, imported the mesh from Pointwise and set the CellZone "rotor" with topoSet. First, i tried to simulate the flow without rotation of impeller, the simulation didn't crash and the results are good. When i switch on the rotation in the MRFProperties the simulation crashes. P.S. The turbulence model i've used is the mixtureKEpsion. Thanks for the attention and i'll be wating your precious suggestions. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Car external aerodynamic with wheel spinning issue | hokhay | FloEFD, FloWorks & FloTHERM | 2 | August 18, 2016 04:23 |
Problems with rotating machinery (Centrifugal Pump) in FLUENT | RR2 | FLUENT | 1 | January 17, 2016 05:23 |
Modelling rotating machinery other than AMI rotating meshes | fedvasu | OpenFOAM Running, Solving & CFD | 6 | March 7, 2014 01:35 |
Rotating machinery modeling | pstreuf | FLUENT | 0 | June 16, 2009 08:40 |
Free rotating machinery CFX seminar | ANSYS CFX Marketing | CFX | 0 | October 6, 2003 11:14 |