 |
 |
 |
|
|
|
[Sponsors] | ||||
November 14, 2008, 01:40
|
Dear All,
When I run parav
|
#1 |
|
New Member
Zhizhong Li
Join Date: Mar 2009
Posts: 8
Rep Power: 18  |
Dear All,
When I run paraview, it crashes with segmentation fault. Below are the trace results: Anybody can help? Thank you. |
|
|
|
|
|
November 14, 2008, 04:53
|
I cannot see a trace or attach
|
#2 |
|
Senior Member
Mattijs Janssens
Join Date: Mar 2009
Posts: 1,419
Rep Power: 27 |
I cannot see a trace or attachment. Does the trace show a problem in any of the OpenFOAM reader (the vtkPV3Foam class or the PV3FoamReader class)? If not it might be a generic paraview problem.
|
|
|
|
|
|
|
November 14, 2008, 05:10
|
Please look at the third post
|
#3 |
|
New Member
Zhizhong Li
Join Date: Mar 2009
Posts: 8
Rep Power: 18 |
Please look at the third post on this topic. Something wrong when I attached the trace results, I finally had to seperate it into three parts. Thanks.
|
|
|
|
|
|
|
November 14, 2008, 07:07
|
The problem has been solved by
|
#4 |
|
New Member
Zhizhong Li
Join Date: Mar 2009
Posts: 8
Rep Power: 18 |
The problem has been solved by:
remove qt 4.3.2 install libq4-dev recompile PV3FoamReader |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ParaView Segmentation fault | zzli | OpenFOAM Bugs | 0 | November 14, 2008 01:51 |
| ParaView Segmentation fault | zzli | OpenFOAM Bugs | 0 | November 14, 2008 01:48 |
| [Technical] Segmentation fault in map | msg30 | OpenFOAM Meshing & Mesh Conversion | 6 | March 27, 2008 11:49 |
| segmentation fault | Sheila | Siemens | 8 | October 9, 2005 06:40 |
| Segmentation fault??? | LiQiang | Main CFD Forum | 3 | March 18, 2005 14:25 |
Linear Mode
